Adding in delays- VideoGrabber

Hi,

Is it possible to add a delay to the videograbber so that the image takes more time to load?

Thanks!

set the framerate lower?

I guess that could work but if there was anyway to do it so after it loaded there wasn’t the choppy motion…

How much delay?
If it’s less than a second, then you could probably have a queue of frames, or a circular array of frames.
If it’s more than a few seconds then that would take too much memory I guess… maybe recording bits of video would work in that case.

I ended up putting in three timers that loads it more slowly but it does take up a lot of memory. I’m putting in between 20-50 second delays.